When I play the rim of my crash 1 pad, it triggers the sequencer to begin playing a loop. When the loop is playing, if you hit the rim again, it stops.
It only does it on a few factory sets. I had to reset the entire module today, and I never had this problem before.
I didn't push any buttons on the module to make it start doing that, it did it by itself. I don't even use the sequencer.
I am scared that will happen live, is there a way to "lock" it off?
Any ideas?
Thanks-
Joe
It only does it on a few factory sets. I had to reset the entire module today, and I never had this problem before.
I didn't push any buttons on the module to make it start doing that, it did it by itself. I don't even use the sequencer.
I am scared that will happen live, is there a way to "lock" it off?
Any ideas?
Thanks-
Joe