Welcome! If this is your first visit, you will need to register to participate.

DO NOT use symbols in usernames. Doing so will result in an inability to sign in & post!

If you cannot sign in or post, please visit our vBulletin Talk section for answers to vBulletin related FAQs.

Announcement

Collapse
No announcement yet.

TD-10 noisy?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Enjoy the Music.com
    replied
    Hi,

    If the hiss is of the CONSTANT low-level variety from the brian (reguardless of voilume output setting), just increrase the volume to raise the output level of your drumming. This may help to mask the hiss a bit. Then you can use a sound editor to remove the hiss during quiet parts (use DARTECH Dart Pro 98 here). Hope this helps.

    Yes, the TD-10 SHOULD be dead quiet, though yours might not be :-( .

    Enjoy the music,

    Steven R. Rochlin http://www.EnjoyTheMusic.com

    Leave a comment:


  • Raffy85
    replied
    I think its the output from the brain. I tried different cables the the problem persisted. Maybe there's a noisy circuit or two in there?

    Raffy85

    [This message has been edited by Raffy85 (edited May 10, 2001).]

    Leave a comment:


  • szvook
    replied
    Originally posted by Raffy85:
    Ok, I'll try adjusting the eq. I have a 8 channel snake that is dead quiet. When I turn the brain off the noise goes away. I usually run into a Mackie 1604, but this time I was running direct into the recorder.

    Raffy85
    Since that is the case, I would say it's the cable(s), if not then it could be the output from the module and I hope that is not the case.

    ------------------
    szvook

    Leave a comment:


  • Raffy85
    replied
    Ok, I'll try adjusting the eq. I have a 8 channel snake that is dead quiet. When I turn the brain off the noise goes away. I usually run into a Mackie 1604, but this time I was running direct into the recorder.

    Raffy85

    Leave a comment:


  • szvook
    replied
    Maybe the internal EQ needs to be lowered, some times that could lead to additional noise. It also could be your outboard mixer (if using one), bad cables.

    I was able to get rid of that noise factor with my Behringer 4-Band Parametric Tube Equalizer. The low and high frequency bands can be used as shelving filters, allowing you to effectively eliminate low-frequency disturbances and high-frequency noise


    ------------------
    szvook

    Leave a comment:


  • Raffy85
    started a topic TD-10 noisy?

    TD-10 noisy?

    Hi everybody! This morning I did some recording into a VS-1680 hard disk recorder, and there was a lot of "white noise" or "hiss" on the recording. I had noticed it before when practicing, but didn't think it was that bad. I'm using the all six of the direct outs(kick, snare, toms stereo, cymb stereo). I tryed switching to another kit that used the master outs instead, but no change.

    Raffy85

    [This message has been edited by Raffy85 (edited May 09, 2001).]

    [This message has been edited by Raffy85 (edited May 09, 2001).]
Working...
X