Fix broken TD-12 Kit , broken mount & limping screen

[only4vdrum Registered Member Find all posts View Profile Close only4vdrum]

Hello guys

Now I finally got an used TD-12 kit I had been expecting for decade at dirt-cheap price.

But it was in a very poor condition with broken mounts and limping screen.


limping_screen.jpg

broken_mount.JPG


All right, let's fix it DIY.


At first, I thought it's easy to take the screen out from the front. I got fooled.
You could try the same way to have fun.


fake_screw.JPG


There is no getting away to strip her from the bottom piece by piece.


bottom.JPG


She also gets buttons on both sides. Take them off gently, please.


side.JPG


Remove all inside connectors carefully.


remove_circuit_connectors.JPG


FFC (Flex Flat Cable) are very delicate. deassemble them with nothing but skill.


remove_FFC.JPG


Now you can see the target, screen module.


screen_module_onRack.JPG


screen_module_front.JPG


Replace all suspect capacitors. All 4 capacitors cost only TWD 20 (= USD 0.6)



Warning: It's super hard to replace capacitors. Find a skillful technician for help.



suspect_capacitors.JPG

Testing .........

testing.JPG



Screen got back alive.


screen_normal.JPG



Fixed mount, nothing big, it works.


fixed_mount.JPG



All above is only for TWD 40 (= USD 1.6 )

[Cheddies Registered Member Find all posts View Profile Close Cheddies]

I love that you managed to fix the screen rather than just replace it. Also, cable ties can fix anything that duct tape cannot!