Hi all, I build an electronic drum with an old td3 module without any problem. Now I tried to replace the td3 with a td11 module and all seems to be ok except the bell ride. I found some wiring schemes but none of them seem to work. I tried to put a piezo between the sleeve and tip and sleeve and ring without success. I tried also to connect a two zone e-cymbal to the bell connector but neither the piezo nor the switch (edge) seem to work.
The questions are: which is the correct use of a ride bell connector ? Piezo or switch ? I should use tip or ring ? There are some options on the module that I don't understand ?
Thanks
The questions are: which is the correct use of a ride bell connector ? Piezo or switch ? I should use tip or ring ? There are some options on the module that I don't understand ?
Thanks
Comment