TD20 base rework

[thebaron]

Has anyone come up with (or put any thought into) a way to make a TD20 module mount so the module is easily removed without keeping the base/stem attached?

I'm considering triggering acoustic drums for gigs and I'd like to easily remove the module and sit it flat on a crate next to me.

Also, there have been many discussions about carrying cases, for example, walmart gun cases, that would fit perfectly for transport if it weren't for the stem of the mount sticking out.

Hart's multipad has a sliding mounting set up that works well for a relatively heavier and bulkier piece of hardware (that you're hitting). Why can't the TD have a base like that? I'd love to keep the base clamped to my rack and simply slide the brain off for transport and to sit flat on a crate.

[stickinthemud]

OK, I'll try to do this without having to draw it out.

1. Take the base/stem off the module.
2. Replace only the top two screws (those closest to the inputs), screwing them in only 3 or 4 revolutions.
3. Starting at the top of the base/stem, cut slots from the edge, just wide enough to allow it to slide onto the shafts of the screws. You will also need to grind off a portion of the lip to allow the heads of the screws to clear.

Once you have done all this, you should be able to just slide the module onto the base/stem. You may want to tighten the two screws for safety's sake, or use a little temporary Loctite so they don't vibrate loose. When you want to un-mount the module, just loosen the screws slightly and slide the module up. You may want to add rubber feet to keep it sitting squarely on your crate, or to keep the screws from scratching a nicer surface.

Dang. This is such a good idea, I think I'll do it too!

[Hercules]

In a word - velcro

[Jemmo]

[JrummerJ]

In a word - velcro

This is what I was thinking. You can get some Velcro Xtreme from places like Home Depot. I have a mixer mounted like that and I am pretty sure it wouldn't come off even if my rack fell down the stairs. Tough stuff.

J

[NicStix]

This is what I was thinking. You can get some Velcro Xtreme from places like Home Depot. I have a mixer mounted like that and I am pretty sure it wouldn't come off even if my rack fell down the stairs. Tough stuff.

J

Or buy one of these .. http://www.drum-tec.de/drumtec-td20-case-p-545.html .. have had this for some time now, and its perfect for the module with base mount fitted. I also use an upright tube mount to fix the module to the rack, very fast, very easy..

[thebaron]

Great ideas guys! Thanks.
That case looks great, however, I have a pintech clamp holding the mount and it's a total PAIN to get the mount in and out of the clamp. I have to wiggle and twist it repeatedly. Not exactly quick release and risky that I'll whack the brain on something as it finally pulls free lol. I might try the heavy duty velcro method first...simplest and can easily be undone. The slot idea is great, too.

[Michael Render]

I have used Velcro - so I am going to +1 that suggestion.